peugeot boxer key fob 308 Key Fob Replacement
Peugeot’s 308 might seem somewhat old-fashioned but it’s still striking. It might not be the most luxurious car in its class and the Ford Focus or Volkswagen Golf will protect you from sloping surfaces — however, it’s a comfortable and comfortable drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is constant or intermittent, the following tips should aid.
Water Damage
When you accidentally leave your fob in the midst of a puddle or get it wet when kayaking, swimming, canoeing, rafting, or canyoning, it’s more likely to suffer water damage. Keep your key fob in a dry container whenever you go outdoors or do things that expose it to large amounts of water.
It is also important to make sure that the fob is completely dry before opening it up and reusing it. If you notice any odors emanating from the fob like an industrial smell or a sour taste like windshield washer fluid, it’s another indication that it’s submerged in water.
A circuit that is wet can cause the battery’s charge to drain or even explode. If you can remove your keyfob 308 from the water, turn the button side up and shake as much water out as you can before opening the casing. Take the battery out, and then clean the circuit board using a cotton swab that has been dipped in 90-percent alcohol.
Other reasons why your peugeot 206 key programming 308 remote keyless entry system might stop working include a dead battery for your coin or receiver module issues signal interference, an electronic chip that is damaged. If none of the above are the problem, you can reset the system by removing the 12 volt battery from your car for 15 minutes.
Dead Coin Battery
peugeot partner key fob cars are equipped with a remote-start system which allows the driver to start the car key cover peugeot — check this site out — from a distance and then warm up or cool down the vehicle prior to stepping inside. This feature is very useful particularly during the cold winter months. The remote start system may be stopped for a variety of reasons, including an inactive coin-battery.
The coin-shaped battery inside the key fob will last between two and four years depending on how frequently it is utilized, the place it was purchased and how it is used. The date of use is typically written on the package or marked in the manual.
If the key fob stops working after being exposed clean tapwater, remove the battery and clean the electronic chip using an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing. If the key fob has been exposed to salty or soapy water, it may have caused the chip to become damaged. It is necessary to replace it.
If you’re not sure if the battery is defective you can check the voltage using a multimeter attached to both the terminals plus and minus. The voltage should be between 12-13 volts, however, if it reads lower, the battery needs to be replaced. You can also reset the onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should start after this.
Faulty Receiver Module
If you’re not getting the «Key Detected» message on your dashboard, it’s possible the receiver module has discovered a problem. It’s the part that transmits an alert to the car when the key fob is activated which acts as an immobiliser, and stops it from starting until the key that you want to use is present.
This could be due to a variety of reasons, including water damage or simply getting old. If the electronic chip within your Peugeot 308 keyfob has been damaged by dirty tap water, it could be because the keyfob was contaminated with it. In this situation, you’ll have to remove it and clean it thoroughly using isopropyl or an electronic cleaner. Once the battery has dried, you can try again.
If the issue is not resolved, it is a good idea to visit the local Peugeot expert or locksmith. They can utilize the diagnostic tool to pinpoint the issue and repair it.
Losing your Peugeot car keys could be an extremely stressful experience. However, a reputable auto locksmith can address the problem in minutes. They can program your car and cut a new working key for you. Find a locksmith in your area.
Electronic chip malfunctions
The electronic chip in the Peugeot 308 key fob is an crucial component of the remote control system. If it is damaged, your car might not start, or you could receive a message that reads «anti-theft active». In this instance, the only solution is to replace the key. Fortunately, auto locksmiths with experience can provide the service in the shortest time.
The chip inside the key fob of your Peugeot 308 may become faulty for various reasons, such as sweat, water damage or dirt. If your Peugeot key fob has been exposed to soapy or dirty water, it must be cleaned as soon as possible. You can make use of a paper towel and isopropyl alcohol to clean the electronic component. Then, you need to let the battery completely dry.
Sometimes keys may cease to function due to radio interference. This can happen when other devices use the same frequency as your Peugeot keyfob. This could be due to problems with the environment or objects within the vicinity of the vehicle. It is recommended to see a Peugeot dealer in the event of this issue.
The Peugeot 207/308 Key Fob is very delicate and requires special care. You should not drop it or throw it around. If you lose something, try to locate it as soon as you can. You can reset your on-board computer by disconnecting the battery for a few minutes. Be sure to disconnect the negative cable first before connecting the positive.